have vertical coloums that im running cascade and drain to waste. Looking into possiably turning into low pressure aereoponic. Plant sites are about 10 inches apart. Looking to install slide in nozzels between plant sites with possiably dual cone spray. And since ill have these on tubing they most be low profile. planning on running two coulums per rail and perhaps filter on every rail ..

ok, sounds interesting. show some pics and share the fun with all of us. Is everything going well in the grow? Did you have a question? Or was this intended more as an introduction? In any case, welcome and please feel free to share your successes and failures and even allow us to help during times of disaster with fast answers.

Peace

well my only aeroponic experiance is with homeade cloner. I have bunch of those 360 nozzels. But dont think that would work good for this system. Im basically trying to turn cannabis cage type system into aeroponic. And putting rail on inside of coloum isnt option, so i wanted to drill small hole for nozzle and tubing to slide inn. Basically i dont know s$#t about nozzles. It needs to be low profile as in no bigger then tubing. Not sure but i think dual outlet cone or 90 degree maybee ?

im aware that nozzle maybee a little bigger then tubing i can run larger section tubing over small stuff in conjunction with rubber groment in coloum should give room. just not sure what best nozzle for 4 3/4 fence post vertically

your 360 nozzles will work great. at the bottom, I would put a 90 then between each plant a 360. That way roots are getting sprayed from two side and finish at the top with another 90

somehow I am picturing a big swamp cooler converted into a grow chamber. forgive me, I am stoned.
On the serious side, depending upon the system, they could work but more likely you want to decide how many of each kind of nossel you need and go down and buy them all for less then $10. Then you will have custom created your grow system.

Need a drwing or some kinda a pic. I ain't very smart. But if I have a visual I may have an idea or two..

nutti imagine your setup standing up, the pots are on a 45 degree angle from the tubes instead of 90 degrees like yours

well shit if that's the case why not just get them laser drilled feeder lines and some grommets. Bam sprayers..

thnx guys ...... i feel better about using these nozzles. I may try couple differnt brands and run test to see how they will handle. Thinks i go with 180 degree on top and bottom. Nut what brand of nozzle came with your system ? and what is spacing. Anyone have good pressure and nozzle companion info ? If i was able to design new system i would go with 5 gallon square buckets welded together with high pressure aeroponic system drain to waste. I will borrow camera and take some pics sometime. Could show how to design and build vertical system for fraction of cost....